Back to Router Bearings

Filters

,

Carbitool Router Bit Ball Bearing 1/2″ TB7

$11.70

Carbitool TB7 replacement ball bearing for router bits — 1/2″ OD x 1/4″ ID x 5/32″ width. Precision sealed bearing suits profile and flush trim bits using a 1/4″ pilot pin. Drop-in replacement to restore accurate, chatter-free cuts. Product Group TB.

Availability: 1 in stock

Barcode: 9314350009479Brand: CARBITOOL Categories: ,

Description

Carbitool TB7 — Router Bit Ball Bearing available at Alltools Geelong. Shop our full Router Bit Ball Bearing range in Geelong.

Carbitool

TB7 Ball Bearing for Router Bits — 1/2″ OD x 1/4″ ID

Part No: TB7  |  Product Group: R739  |  Discount Group: Z0904

The Carbitool TB7 is a mid-series replacement bearing with a 1/2″ OD and 1/4″ ID bore. Suits a range of Carbitool profile and flush trim bits where a 1/2″ OD bearing is used as the guide. Verify your bit’s bearing seat OD before ordering.

1/2″ OD (12.70mm)
1/4″ ID (6.35mm)
5/32″ Width (3.97mm)
Sealed Bearing
Replacement Part

Key Features & Benefits

  • Precision-ground sealed bearing — smooth, consistent rotation keeps profile bits tracking true against the workpiece edge without chatter or drift.
  • Easy field replacement — when a bearing wears, seizes, or runs rough, swap it out rather than replacing the whole bit assembly.
  • Genuine Carbitool part — matched to Carbitool router bit bearing seats for correct fit and clearance.
  • Keep bearings clean and lightly oiled — clean in acetone or glue solvent after use; apply a drop of light machine oil to maximise service life.

When to Use This Bearing

The TB7 suits Carbitool and compatible profile bits that use a 1/2″ OD x 1/4″ ID bearing. If your existing bearing has seized or is running rough, a TB7 replacement restores accurate guidance without replacing the full bit. Always clean the bearing seat before fitting.
Pro Tip: After routing in resin-heavy timbers or materials with adhesive, clean bearings immediately in acetone or glue solvent — dried glue in the bearing race is the most common cause of premature bearing failure. A drop of light machine oil after cleaning keeps it spinning freely.

Product Specifications

TB Series — Carbitool Replacement Ball Bearings for Router Bits
Part No. OD inch OD mm ID inch ID mm Width inch Width mm Barcode
TB6 1/4″ 6.35 7/64″ 2.78 5/64″ 1.98 9314350009585
TB7 1/2″ 12.70 1/4″ 6.35 5/32″ 3.97 9314350009479
TB8 5/8″ 15.88 3/16″ 4.76 3/16″ 4.76 9314350007635
TB9 3/8″ 9.53 1/8″ 3.18 9/64″ 3.57 9314350007642
TB10 3/8″ 9.53 5/32″ 3.97 9/64″ 3.57 9314350007659
TB11 1/2″ 12.70 3/16″ 4.76 3/16″ 4.76 9314350007666

★ You are viewing the highlighted variant. Other sizes in this series are also available.

Reviews

There are no reviews yet.

Be the first to review “Carbitool Router Bit Ball Bearing 1/2″ TB7”