Description
Intech Tools MTPROSH — intech square head protractor stainless available at Alltools Geelong. Shop our full intech square head protractor stainless range in Geelong.
Intech Tools
Intech 180° Square-Head Protractor — Stainless Steel
Part No: MTPROSH | Barcode: 9333608007517 | Series: Intech Layout & Marking Tools
Intech’s MTPROSH is a 180° hardened stainless-steel protractor with a square head, giving you accurate angle measurement and marking-out across a full half-circle. The square base sits flat against an edge for reference-free angle transfer, making it a dependable workshop tool for woodworkers and metalworkers alike.
180° Range
Square Head
Hardened Stainless Steel
Etched Graduations
Compatible Work
Timber
Steel & Alloys
Aluminium
Composite Panels
Key Features & Benefits
- Full 180° graduated scale — read angles either side of vertical from a single reference face, suitable for bevels, mitres and layout work.
- Square-head reference base — provides a clean 90° reference against the workpiece edge so the angle reading is measured directly from the work, not triangulated from another face.
- Hardened stainless steel — resists corrosion and keeps the etched scale legible through years of workshop handling; edges remain true and the graduations don’t wear off under use.
- Etched (not printed) graduations — lines are cut into the face, so oil and solvent won’t lift them and the scale remains readable in shop conditions.
- Versatile for wood & metal — use for marking out mitre joints in cabinetry, checking bevel cuts on the bandsaw, or laying out angle plates for fabrication work.
When to Use the MTPROSH
Use the MTPROSH when you need to transfer or mark out an angle between 0° and 180° from a flat reference edge — mitre joints, bevel cuts, layout for welding fixtures, or pattern work in sheet metal. For angle work that needs to pivot around a cylindrical or irregular surface, a round-head protractor (MTPRORH) or sliding bevel is more appropriate.
Pro Tip: When transferring a site-measured angle to stock on the bench, always mark from the same face as the square head reference — flipping the protractor onto the opposite face inverts the angle reading and is the most common source of mis-cut bevels. A small arrow in pencil on the reference face takes three seconds and eliminates the mistake.
Authorised Australian Dealer — This product is backed by full Australian manufacturer warranty from Intech Tools, with local support and service through Alltools Geelong.
Reviews
There are no reviews yet.