Description
Makita D-02048 — Flush Trim Router Bit available at Alltools Geelong. Shop our full Flush Trim Router Bit range in Geelong.
Makita
D-02048 Flush Trimming Router Bit — Makita Trimmer Compatible
Part No: D-02048 | Barcode: 88381172264
The Makita D-02048 is a flush trimming router bit designed for use with Makita laminate trimmers. It trims plastic laminate, edge banding, and veneer flush with the substrate surface, delivering a clean, professional edge without overcutting.
Flush Trimming
Makita Compatible
Ball Bearing Guide
Laminate Trimming
Edge Banding
Specifications
- Cutter Diameter — 1/2″
- Overall Length — 1-5/8″
- Working Length — 1/4″
- Shaft — 1/4″
- Max Speed — 30,000 rpm
Suitable For
Plastic Laminate
Edge Banding
Veneer
Laminates
Sink Tops
Key Features & Benefits
- Flush Trimming Capability — trims laminate and edge banding exactly flush with the substrate edge in a single pass, eliminating manual filing or sanding.
- Ball Bearing Guide — the integrated bearing runs along the substrate face, ensuring the cut stays perfectly flush without overcutting into the panel.
- Makita Trimmer Compatible — designed to fit Makita laminate trimmers with 1/4″ collets, the most widely used trimmer platform in the industry.
- Clean Edge Finish — produces a smooth, chip-free edge on plastic laminate suitable for immediate use without further finishing.
When to Use This Bit
Choose the D-02048 for flush trimming plastic laminate, veneer, and edge banding on bench tops, cabinet doors, and panel edges using a Makita laminate trimmer. Always ensure the bearing runs cleanly on the substrate face and that the substrate edge is square and clean before trimming. For non-Makita trimmers, verify collet compatibility before purchase.
Pro Tip: When trimming laminate on a bench top, run the trimmer in the correct direction (against the rotation) to prevent chipping at corners. A light feed rate and sharp bit produce the cleanest edge.
Reviews
There are no reviews yet.