Description
Master Q
Master Q 45° Elbow — 25mm Push-Fit (727156307)
Part No: 727156307 | Barcode: 22119 | System: PE100 SDR11
Master Q 727156307 is a 25mm push-fit 45° elbow used to make gentle, low-loss bends in a 25mm compressed-air poly line. The shallow 45° angle routes the run around obstacles with less turbulence than a square corner, and both ends push-fit and hand-tighten in the Master Q poly piping system.
25mm — 25mm
45° Bend
Lower Flow Loss
Push-Fit Compression
Demountable
Suitable For
Gentle Direction Changes
Routing Around Obstacles
Offsets & Doglegs
Workshop Reticulation
Key Features & Benefits
- 45° angle — a shallower bend than a 90° elbow, useful for offsets and for keeping flow losses down on long runs.
- Push-fit compression ends — seal onto 25mm pipe with O-ring and collet for a demountable join.
- Pairs with a second 45° — two 45° elbows form a neat dogleg around obstructions without a sharp corner.
- Matched to the Master Q system — interchanges with the rest of the 25mm range.
When to Use This Fitting
Use the 727156307 45° elbow when you want a softer bend than a right angle — stepping a line around beams or columns, or forming an offset. Two together make a clean dogleg. Combine with the other Master Q fittings in the table below.
Authorised Australian Supplier — This product is part of the Master Q compressed-air piping system, sourced from Master Q Australia with full local supplier support and warranty.
Master Q Compressed-Air Poly Piping System
| Part No. | Type | Size / Connection |
|---|---|---|
| 025PE100/10 | Poly Pipe (PE100 SDR11) | 25mm × 6m length |
| R210.025.025 | Straight Coupler | 25mm — 25mm |
| R213.025.025 | 90° Elbow | 25mm — 25mm |
| 727156307 ★ | 45° Elbow | 25mm — 25mm |
| R214.025.000 | Equal Tee | 25mm — 25mm |
| 727206308 | Equal Tee | 32mm — 32mm |
| R221.025.000 | End Cap | 25mm |
| EP3 | End Cap | 32mm |
| C3 | Straight Coupler | 32mm — 32mm |
| M31-2520 | Female Threaded Connector | 25mm — 3/4″ BSP F |
| 727116307 | Female Threaded Elbow | 25mm — 3/4″ BSP F |
| R215.025.012 | Threaded Tee | 25mm — 1/2″ BSP F |
| 158001920 | Wall Plate | 25mm — 3/4″ BSP F |
| PC25 | Pipe Clip | 25mm |
| PCC32 | Pipe Clip | 32mm |
| SV14-10 | Safety Relief Valve | 1/4″ BSP |
★ You are viewing the highlighted item. The Master Q poly piping range push-fits together — mix pipe, couplers, elbows, tees, threaded take-offs and clips to build your compressed-air reticulation.
Browse our wide range of air fittings & piping at Alltools Geelong.
Reviews
There are no reviews yet.